Hi all, Just wondering if anyone else has had this issue or can offer some assistance.
I put the drone up from a large yacht over water as had been done many times in the days prior. Controller said it was in a "no fly zone" and engaged auto landing. Drone was over water so I clicked cancel but it didn't respond. Drone got to about 10cm above water level and said it couldn't auto land due to unsuitable surface, or something along those lines. Then said auto landing again, and was sort of hovering just above water level and moving up and down. I kept full power up on the controller and flew it towards the boat, but it refused to ascend and ended up crashing into the ocean and sinking immediately.
I've logged an issue with DJI and ultimately I'd like them to replace the drone, as it seems like an error occurred which caused the crash.
This is a first time post so I hope the logs attached work!
I put the drone up from a large yacht over water as had been done many times in the days prior. Controller said it was in a "no fly zone" and engaged auto landing. Drone was over water so I clicked cancel but it didn't respond. Drone got to about 10cm above water level and said it couldn't auto land due to unsuitable surface, or something along those lines. Then said auto landing again, and was sort of hovering just above water level and moving up and down. I kept full power up on the controller and flew it towards the boat, but it refused to ascend and ended up crashing into the ocean and sinking immediately.
I've logged an issue with DJI and ultimately I'd like them to replace the drone, as it seems like an error occurred which caused the crash.
This is a first time post so I hope the logs attached work!