Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Search
Search titles only
By:
Search titles only
By:
Menu
Welcome DJI Spark Pilot!
Jump in and join our free Spark community today!
Sign up
Forums
General Forums
Firmware & Software Discussion
Can't connect to WiFi of rc
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Dronason" data-source="post: 54498" data-attributes="member: 553"><p>If you have the remote controller (RC), it is highly recommended to use it. See manual page 38 how to connect it. In any case for reasonable use, you will need it.</p><p>There are 2 mode for the connection to Spark, with the RC or directly with your device (phone or tablet). The switch between these modes are done using the button on the battery of the Spark.</p><p>See again end of page 38 and begin of 39 for how to switch from one mode to the other.</p><p>When the Spark is set to use the RC, it don't show any wifi SSID et it is the to the RC wifi that you need to connect.</p><p>In direct mode, the Spark generate a visible wifi signal. At start the Spark decide which band to use 2.4/5.8G and if RC used, then the RC use the other band. Some android devices had issue to connect to 5.8G wifi band if you are in a non FFC country (CE). That was my case with a S6 where a S8 or IOS devices have not that issue. </p><p>Hope it helps.</p></blockquote><p></p>
[QUOTE="Dronason, post: 54498, member: 553"] If you have the remote controller (RC), it is highly recommended to use it. See manual page 38 how to connect it. In any case for reasonable use, you will need it. There are 2 mode for the connection to Spark, with the RC or directly with your device (phone or tablet). The switch between these modes are done using the button on the battery of the Spark. See again end of page 38 and begin of 39 for how to switch from one mode to the other. When the Spark is set to use the RC, it don't show any wifi SSID et it is the to the RC wifi that you need to connect. In direct mode, the Spark generate a visible wifi signal. At start the Spark decide which band to use 2.4/5.8G and if RC used, then the RC use the other band. Some android devices had issue to connect to 5.8G wifi band if you are in a non FFC country (CE). That was my case with a S6 where a S8 or IOS devices have not that issue. Hope it helps. [/QUOTE]
Verification
Post reply
Forums
General Forums
Firmware & Software Discussion
Can't connect to WiFi of rc