Recent content by Abhiman

because i want to fly and test the drone behavior in no GPS and zero light condition.

How spark can lift 5-6 m long loop..??

Is there any way to bluff the VPS sensors of spark so that it will always judge that it is flying at height of 5 to 6 m from the ground.

That's why I blind the sensor by black insulation tape. And then the spark is gaining its altitude by it's own.

And this is not with one single spark, I have 5 spark with me and out which 3 spark are behaving same altitude restriction.

I did that also sir, beginnermode will not allow me to go beyond 30 m I know, so I tried to do fly in sports mode as well by changing the maximum height restrictions to100 m. But still it stuck in 30 m. I degraded the firmware by DJI assistance and it was flying well and gaining altitude in...

No, I was flying with transmitter not with device

My spark was flying pretty well at low altitude and I decided to go little high but suddenly my drone was stuck at height of 30m. It was not gaining altitude after giving of full throttle command also. I tried to celebrate all sensors properly. I factory reset it aslo and as well I downgrade my...

I was flying my drone in pitch dark condition where there was zero GPS and no single source of light found. It was flying in atti mode and suddenly it's yaw rotation started by it's own. The speed of yaw rotation was so fast that I can't counter control the rotation with my transmitter sticks...

Do your calibration by always facing earth magnetic North direction. Chances of calibration fail are very less in this condition.

I don't think there should be any issue. I am flying spark generally with my friends. We do FPV kind of racing with spark sometimes I haven't faced any issue.

How to turn off spark bottom 3D camera sensors. Because my spark is gaining auto altitude when it comes under dark places. It was flying at atti mode and suddenly it is gaining it's altitude without any throttle input and it went up and hit the selling.