I am an electronics hobbyist.
My intention is to drive TX of ESC chip myself. Currently I have a few hardware below
1) DJI Spark Brushless Motor 1504s
2) ESC Board for DJI Spark Part
3) Some FPGA development board.
I can build hardware or build some MCU system to write some firmware code.
I thought I can have a lot of fun by driving TX of ESC myself using my own hardware/firmware code, to test drone flying control.
I can even build some prototype by integrating my own host system with the 4 DJI spark ESC+motor.
So hope someone can share some typical TX commands/patterns required. Thanks!
My intention is to drive TX of ESC chip myself. Currently I have a few hardware below
1) DJI Spark Brushless Motor 1504s
2) ESC Board for DJI Spark Part
3) Some FPGA development board.
I can build hardware or build some MCU system to write some firmware code.
I thought I can have a lot of fun by driving TX of ESC myself using my own hardware/firmware code, to test drone flying control.
I can even build some prototype by integrating my own host system with the 4 DJI spark ESC+motor.
So hope someone can share some typical TX commands/patterns required. Thanks!