Menu
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Search
Search titles only
By:
Search titles only
By:
Menu
Welcome DJI Spark Pilot!
Jump in and join our free Spark community today!
Sign up
Forums
General Forums
General Discussions
AutoPilot and the Spark
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Thanne99" data-source="post: 52443" data-attributes="member: 10626"><p>So today i tried another mapping test. I saw that addvice of Chrislaf and set the gimbal to 85°. But this didnt work neither. What i found out is that the spark will take picture during waypoint mode if you touch the camera button on your RC or the little white spot in the camera screen in AP (look at the picture below, the red button). But i dont understand how it works. So far i understand that you can change between different photo modes e.g. Burst, Single, RAW Burst and so on. If you touch the button it will change to a red button on the screen which says: 3/10s. I dont know what that means. Photos will be taken for more then 10sec. On my little waypoint mission i had to pull the trigger 3 times. Maybe anyone can use this information to solve finally the problem.</p></blockquote><p></p>
[QUOTE="Thanne99, post: 52443, member: 10626"] So today i tried another mapping test. I saw that addvice of Chrislaf and set the gimbal to 85°. But this didnt work neither. What i found out is that the spark will take picture during waypoint mode if you touch the camera button on your RC or the little white spot in the camera screen in AP (look at the picture below, the red button). But i dont understand how it works. So far i understand that you can change between different photo modes e.g. Burst, Single, RAW Burst and so on. If you touch the button it will change to a red button on the screen which says: 3/10s. I dont know what that means. Photos will be taken for more then 10sec. On my little waypoint mission i had to pull the trigger 3 times. Maybe anyone can use this information to solve finally the problem. [/QUOTE]
Verification
Post reply
Forums
General Forums
General Discussions
AutoPilot and the Spark